Fax +32 2 359 95 50
IMPORTANT SAFEGUARDS
Please read these instructions carefully before using the appliance.
Important: People (including children) who are not able to use the appliance in a safe way,
due to their physical, sensorial or mental capacity or their lack of experience or knowledge,
must never use the appliance except if they are supervised by a person responsible for their
safety or if they previously received instructions concerning the safe use of the appliance.
Close supervision is necessary to prevent children from using the appliance as a toy.
Check that your main voltage corresponds to that stated on the appliance.
Never leave the appliance unsupervised when in use.
Always place the base of the appliance on a stable ironing board, table or on the
ground.
Only connect the appliance to a main earthed wall socket.
To avoid a circuit overload, do not operate another high wattage appliance on the same
circuit.
The iron shall be used and placed on a stable level surface.
When you place the iron on its support, make sure that the surface on which you put it is
stable.
Do not use the iron if it has fallen, if it shows any visible signs of damage or if it leaks.
If an extension cord is absolutely necessary, a 10-ampere or higher cord should be used.
Never use cords rated for less than 10-ampere. Care should be taken to arrange the cord
so that it cannot be pulled or tripped over.
Never leave the appliance unsupervised when switched on and especially the steam iron
when it is heating. Keep out of reach of children or incompetent persons.
From time to time check the cord for damages. Never use the appliance if cord or
appliance shows any signs of damage. In that case, repairs should be made by a
competent qualified electrician
competent qualified service
Only use the appliance for domestic purposes and in the way indicated in these
instructions.
Never immerse the iron or the base in water or any other liquid for any reason whatsoever.
Never use the appliance near hot surfaces.
Do not allow power cord and cord binding the base to the steam iron to touch hot
surfaces.
Never use the appliance outside and always place it in a dry environment.
Never use accessories that are not recommended by the producer. They could constitute
a danger to the user and risk to damage the appliance.
Never move the appliance by pulling the cord. Make sure the cord cannot get caught in
any way. Do not wind the cord around the appliance and do not bend it.
Fully unwind the main cord and supply hose before starting to iron.
Always unplug the appliance when it is not in use.
Burns can occur from touching hot metal parts, hot water, or steam.
Always place the iron on the base of the appliance, on the therefore foreseen place. Do
not place iron by its rear cover. Be sure that it does not come in contact with flammable
materials or with the main cord.
Never fill the steam tank with vinegar, descaling agents or other chemicals.
Before the first use, remove any sticker or protective foil from the soleplate. Clean the
soleplate with a soft cloth.
Some parts of the iron have been slightly greased and as a result the iron might slightly
smoke when switched on for the first time. After a short while, however, this will cease.
The iron shall be used and placed on a stable level surface.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
. Should the cord be damaged, it must be replaced by a
(*)
.
(*)
12
Assembly page 12/72
TKG SIS 1000 - 081224