Team kalorik TKG SIS 1000 Manual De Instrucciones página 13

Fax +32 2 359 95 50
Do not use the iron if it has fallen, if it shows any visible signs of damage or if it leaks.
When you place the iron on its support (if available with the model), make sure that the
surface on which you put it is stable.
Proceed the same way if the water tank stops working or is damaged. To avoid the risk of
electric shock, do not disassemble the iron or steam tank, take it to a qualified technician
for examination and repair. Incorrect re-assembly can cause a risk of electric shock when
the iron or steam tank is used.
Fully unwind the main cord and supply hose before starting to iron.
The selector switch should always be set on position
power cord from outlet.
Unplug the appliance and allow the iron and the water tank to cool down before
cleaning or storing them and for pressurized steam iron station (depending on the model)
before opening, filling or emptying the water tank.
FOR PRESSURIZED STEAM IRONING STATION (DEPENDING ON THE MODEL), NEVER TAKE OUT
THE STEAM TANK WHILE THE APPLIANCE IS CONNECTED TO THE MAINS WALL SOCKET AND
ESPECIALLY WHEN STEAM IS BEING PRODUCED.
Competent qualified service: after-sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this service.
STEAM IRON: PRECAUTION FOR USE AND TEMPERATURES
• Always check first if a label with ironing instructions is attached to the article that needs to
be ironed. Follow these ironing instructions in all cases.
•
If ironing instructions are missing but you know the kind of fabric, then see the table for
recommended ironing temperatures.
Temperature Nylon
setting
Fabric Synthetics,
Silk, Nylon,
Acrylic,
Acetate
Ironing
Dry ironing
instructions
Jet of steam
No
• Make sure the handle (2) is down. If not, press both handle
release buttons (10) to lay it down. As soon as you plug in the
appliance, the iron is switched on, even if you haven't
activated the selector switch ("SETTING"). The red power light
of the display switches on as soon as you plug in the
appliance. Press the selector switch (5) to set the temperature.
The blue indicator light of the chosen setting will blink,
indicating that the iron is heating. As soon as the desired
temperature is reached, the indicator light will light up steadily
and a beep will sound. You can start ironing.
• During ironing this blue indicator light will start blinking again
from time to time. When this happens, the soleplate is being
heated up to the required temperature again. You can
continue ironing.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Polyester Rayon
Wool Synthetics
Polyester Wool
Polyester
Dry ironing Steam
on the ironing
reverse side
of the fabric
Yes Yes
13
Assembly page 13/72
before plugging or unplugging the
Cotton Linen
Cotton Polyester
Wool Cotton
Linen
Steam Steam
ironing ironing
Yes
TKG SIS 1000 - 081224
Yes