Tabla De Contenido - Barrette EPN-51920 Manual Del Usuario

12.
Expose other mounting holes by adjusting
the striker assembly out away from the gate
using a screwdriver (Fig. 13, Fig. 14)
13.
Install (2) #10x1 screws (Fig. 15).
14.
Adjust striker assembly back to its previous
position which is identified by the mounting
bracket. Adjust until surfaces are flush.
(Fig. 16)
15.
Hold the gate close to the latch assembly
and adjust the vertical adjustment screw
under the latch assembly and/or the
horizontal adjustment screw on the striker
assembly until the alignment looks like
Figure 17.
NOTE: This latch will not function properly if
the striker & latch assembly is not aligned as
illustrated.
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
5