TEFAL EXPRESS COMPACT Manual Del Usuario página 6

Description
1. Steam control button
2. Iron temperature adjustment dial
3. Iron thermostat light
4. Iron rest
5. Power cord storage space
6. Power cord
7. Water tank
8. Steam generator boiler (in the base unit)
9. Iron-base steam cord
Locking system for retaining the iron on the base - Lock system
• Your steam generator is equipped with a retaining hoop which locks the iron on its base for easier transport
and storage:
- Locking - fig.1
- Unlocking - fig.2
• To carry your steam generator by the iron handle:
- Place the iron on the iron rest of the generator and raise the retaining hoop over the iron until it locks into
place (audible click) - fig.1.
- Grasp the handle of the iron to carry your steam generator - fig.3.
Preparation
What water may be used ?
• Tap water :
Your appliance has been designed to function using untreated tap water. If your water is very hard, we
recommend you use a mix of 50% untreated tap water and 50% distilled water available in most shops.
• Types of water not to use :
Heat concentrates the elements contained in water during evaporation. The types of water listed below may
contain organic waste, mineral or chemical elements that can cause spitting, brown staining or premature wear
of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries, air
conditioners, rain water, boiled, filtered or bottled water. These types of water should not be used in your TEFAL
iron. Also only use distilled water as advised above.
• Always remember :
Never use rainwater or water containing additives (like starch, fragrance or water from domestic appliances).
Such additives can affect the steam properties and at high temperature, form deposits in the steam generator
chamber which are likely to stain your washing.
• Place your steam generator on a stable, flat heat-resistant surface.
• We recommend that you use a mesh type ironing board to allow steam to pass through the garments for better
ironing results and also to prevent steam venting sideways.
• Check that your appliance is unplugged and open the flap on the tank.
• Pour in untreated tap water up to the max mark -
Using your steam generator
• Completely unwind the power cord and the steam cord from its storage space .
• Tilt the locking ring of the iron forwards to release the safety catch (according
to the model).
• Plug in your steam generator to an earthed socket.
• The boiler heats up - fig.14.
When the green "steam ready" light stops flashing (after 2 minutes
approximately), the appliance is ready -
• When starting, and regularly while it is being used, your steam generator's electric
pump injects water into the boiler. It makes a noise but this is quite normal. You may
also hear a clicking noise which is the steam valve opening. Again this is normal.
2
10.
11.
12.
13.
fig.4.
fig.15.
Steam cord storage clip
Boiler rinse cap cover/ Boiler rinse cap
Control panel
a - OK button
b - "Steam ready" light
c - "water tank e mpty" light
d - "boiler rinse" light
Lock-System hoop (depending on model)
Filling the water tank
The first time the appliance is
used, there may be some fumes
and smell but this is not harmful.
They will not affect use and will
disappear rapidly.
(depending on model)