Filtering Time; Operation With Floor Cleaners; Before First Use; Check The Following Before Start-Up - Steinbach Active Balls 50 Manual Original

The timer now controls the running times of the pump.

Filtering time

The pool's water content should be turned over at least three to five times in 24 hours
depending on the use and the size of the system. The operating time depends on the
output of the filter system and the pool size.

Operation with floor cleaners

Use a skimmer with a screen basket or similar device if your filter system
does not feature a prefilter to prevent foreign objects from damaging the
device.
Observe the instruction manual notes of the floor cleaner. Air must not
penetrate the filter system to prevent the system running dry and
overheating.
You can connect the hose of the floor cleaner
directly to the suction line of the filter system.
The hose of the floor cleaner must be
completely filled with water.

Before First Use

Check the following before start-up

1. Make sure that the pump's power cable is disconnected from the power supply.
2. Make sure that the device is located outside the pool and below the water level.
3. Make sure that all feed and drain lines are correctly connected and fastened in place.
4. Make sure that the pool's water level is at least 2.5 to 5 cm above the opening of the
suction line. If this is not the case, fill the pool.

Preparing the filter vessel

1. Remove the locking ring
2. Put aside the locking ring and its wing nut.
3. Screw the riser pipe
44
by unscrewing the wing nut
2
onto the screen
7
2
5
.
8
counterclockwise.