Preparing The Filter System - Steinbach Active Balls 50 Manual Original

Connecting the suction line
Connecting the suction line with the self-fastening hose
- When using self-fastening hoses Ø 32 / 38 mm.
1. Screw a hose adapter
onto the prefilter cover
2. Make sure that water from the supply
or drain line does not flow into the
pool.
3. Push the hose end onto the hose
adapter and use the hose clamps to fix
the hose in place.
The suction line is connected.
Connecting the return line
Connecting the return line
When using push-on hoses.
1. Push one hose end onto the connection for the return line
2. Connect the second end to the connection on the injection nozzle of the pool.
The return line
27

Preparing the filter system

1. Remove the stopper on the suction line if applicable.
2. Check that the suction line is free and then open the shut-off valve on the suction
line.
The filter system fills automatically with water because it is below the water level.
3. Let the filter vessel fill completely with water.
4. Bleed the filter system. Open the prefilter cover
the threaded ring
5. Let the prefilter cover fill completely with water.
6. Check the filter system and the connections for leaks.
In the case of leaks, wrap extra Teflon tape around the affected connections.
clockwise
12
.
11
is connected.
until water flows from the prefilter cover.
13
13
12
on the filter cover
27
on the pump slightly by loosening
11
11
.
1
49