Panasonic CZ-TACG1 Manual Del Usuario página 7

iv. Tap "Next" after confi rming the POWER LED of the
network adaptor is ON.
v. If you are the fi rst user (administrator) to operate the
air conditioner via this application, reset the network
adaptor with a pin and tap "Next".
vi. Choose the button that matches the status of LINK
LED on the network adaptor.
vii. Tap on the preferred connection setup mode.
- To "Connect with WPS mode", proceed to
instruction 3.1 (For router that supports WPS)
- To "Connect with AP mode", proceed to instruction
3.2 (For router that does not support WPS)
3.1 Connect with WPS Mode
i.
ii.
iii. Press and hold the "SETUP" button on the network
iv. Release the "SETUP" button when both STATUS
v.
7
Press the "WPS" button on the router to establish
connection.
Tap "Next" after the router is ready for connection.
adaptor for 5 seconds.
LED and LINK LED start to blink. Tap "NEXT".
Wait until LINK LED is ON indicates the connection
setup is complete. Tap "NEXT" and proceed to
instruction 4.