Publicidad
14. Raise the vehicle hood and disconnect the Negative
(-) battery cable.
15. Route the 12 gauge black wire from the battery
compartment under the vehicle along the frame to a
position near the grommet located in step 11. Secure
the wire to the vehicle using cable ties (included)
(Fig. 7).
Fig. 7
Caution: When routing wire through metal or
other sharp surfaces, always utilize an
existing grommet, provide a grommet
or insulate the wire from the hole with
silicone rubber.
16. Route the 12 gauge black wire up through
the vehicle grommet and into the vehcle's
Fig. 8
spare tire well.
17. At the front of the vehicle, with the fuse removed, attach the 3/8"
ring terminal to the vehicles positive (+) battery terminal (Fig. 8).
Warning: Do not attempt to connect the black power wire to
the vehicle fuse panel or any other accessory wiring. Failure
to connect directly to the vehicle battery could cause vehicle
damage and/or trailer lighting failure.
18. At the rear of the vehicle, Strip 5/16" of insulation from the black
12 ga. wire and connect it to the black wire on the T-Connector's black
box using the yellow butt connector.
19. Reattach the vehicles Negative (-) battery wire.
20. Place the 10 amp fuse into the fuse holder installed in step 17.
21. Confirm trailer harness operation with a test light or by using a
properly equipped trailer.
22. Secure the taillight housings within their openings. return the
spare tire well foam liner, interior trim panels, threshold, floor panels
and pockets to their original positions.
Publicidad
