Tabla de contenido
Publicidad
Installation
Site Requirements
Make sure you observe the following site requirements:
!
Make sure you are placing the switch in a dust-free and moisture-free
environment.
!
Do not block ventilation openings on the unit.
!
Make sure that the switch's power is accessible and cables can be connected easily.
!
Cabling should be away from sources of electrical noise such as radios,
transmitters, broadband amplifiers, power lines and fluorescent fixtures.
!
Do not place objects on top of the switch.
!
Use dedicated power circuits or power conditioners to supply power to the
switch.
Desktop Installation
Place the switch on the desktop using these steps, or perform the steps "Rackmount
Installation" on page 7. The AT-FS709FC can be stacked two or more devices high on the
desktop as described in the steps below.
1.
Attach the four self-adhesive rubber feet to the bottom of the switch, positioning
them in the indentations.
2.
Place the switch on a flat, level surface where power is easily accessible.
3.
To stack more than one switch, repeat step 1 for the additional switches before
stacking them. The rubber feet cushion the switch against shock and vibration
and provide space between each switch for ventilation.
4.
Connect power: attach one end of the power cord to the back of the switch and
the other end to the power source.
The switch performs a self-diagnostic test upon power on, and takes about 20
seconds to complete.
5.
Make sure the Power LED on the front panel lights green.
6
Note
Publicidad
Tabla de contenido
