geberit ECO 301 Manual De Operación página 33

Cleaning and lubricating the pressing tool
Prerequisites
Pressing tool is switched off.
CAUTION
Risk of injury from switching on inadvertently
Disconnect the mains plug before starting any maintenance work on the pressing
tool
CAUTION
Damage to the device from moisture
Never immerse the pressing tool in water or other liquids
1
Clean the roller drive and retaining pin of the pressing tool.
2
Use compressed air or a brush to remove dirt.
3
Use BRUNOX® Turbo-Spray® or an equivalent lubricant to lubricate the roller drive, the
roller drive guide and the retaining pin (see cover page in the back, Figure E).
4
Wipe off any excess lubricant.
5
Clean the pressing jaw detection contacts on the pressing cylinder (see cover page in
the back, Figure E, item 1).
B266-004 © 05-2015
964.869.00.0 (03)
EN
33