Nice OXI Instrucciones Y Advertencias Para La Instalación Y El Uso página 10

PROCEDURE 3 - Memorising a new transmitter "near the receiver"
01. On the NEW transmitter: hold down the key to be memorised;
wait at least 7 seconds then release it.
02. On the transmitter ALREADY MEMORISED: press and re-
lease 3 times the memorised key to be copied.
03. On the NEW transmitter: press and release once the same key
pressed at step 01.
If there are other transmitters to be memorised, repeat the procedure from the beginning for each new
transmitter.
3.4 - Memorising a new transmitter using the "enabling code" of an old transmitter already memo-
rised in the receiver - only for transmitters with "O-Code" and "O-Code/A" encoding system
The memory of transmitters with "O-Code" and "O-Code/A" encoding contains an "enabling code" (secret)
which can be used to enable a new transmitter to be memorised in the receiver. To perform this enabling
procedure, read the transmitter's instruction manual and get an old transmitter already memorised in the same
receiver in which the new transmitter is to be memorised. Warning! - The enabling code can only be transferred
between two transmitters that have the same radio coding.
Subsequently, when the new enabled transmitter will be used, it will send to the receiver (in the first 20 transmis-
sions) the command, its own identification code and the "enabling code" received. At this point, the receiver
will recognise the enabling code of the old transmitter and automatically memorise the identification code of
the new transmitter.
• The undesired memorisation of transmitters through the "enabling code" can be prevented by blocking the
9 - English
x 7 sec
1 1 2
1
3 4
2
1 1 2
1
3 4
2
1 1 2
1
3 4
2