Nespresso VERTUO Manual De Instrucciones página 55

UM_NEW LAYOUT_VERTUO_2.indd 31 UM_NEW LAYOUT_VERTUO_2.indd 31
9 Light blinks while machine is
running.
10 Light blinks and machine is not
running.
11 Light blinks alternately 2 blinks
and 1 pause continuously.
Machine is not running.
12 Light alternately blinking
3 times and then steady on.
VERTUO PLUS
7b Coffee leakage.
• If coffee is flowing normally, this indicates the machine is
working properly.
• If only water is flowing, the machine is executing a user
request for either cleaning, descaling or emptying the
system. Refer to the corresponding paragraph in this user
manual.
• Turn the machine to "OFF mode" by pushing the button for
3 seconds and then push it again to turn the machine ON.
Now wait approximately 20 minutes to allow the machine to
cool down after extensive use.
• It will take some time before the coffee flow comes out (due
to barcode reading and pre-wetting the coffee).
• Check that a fresh capsule is inserted in correct position,
that the handle is properly locked and push the button to
start.
• Fill the water tank and push button to start.
• Turn the machine to "OFF mode" by pushing the button for
3 seconds and then push it again to turn the machine ON.
Now wait approximately 20 minutes to allow the machine to
cool down after extensive use.
• During regular Coffee/Espresso preparation: 1) Unlock the
handle and open the machine head to check that a fresh
undamaged capsule is inserted in the correct position.
2) Check that the handle is in "LOCKED" position. 3) Check
that the water tank is filled.
• During Descaling, Emptying and Cleaning: 1) Check that
capsule is ejected. 2) Check that the handle is in "LOCKED"
position.
• During Programming Volume: 1) Check if a capsule has been
well inserted. 2) Please refer to the corresponding chapter.
• If problem persists:
1. Unlock the handle and open machine head.
2. Replace capsule (if needed).
3. Disconnect powercord from the outlet and plug the
machine back into outlet after 10 seconds.
4. Close the head and press the button to turn ON and press
again to start brewing. If problem persists, call Nespresso.
• Descaling needed: machine can be operated when alert
appears only a few times after this alert before descaling
becomes necessary.
• Open the machine head and let the capsule be ejected.
Then perform a cleaning.
• Empty and clean the cup support.
• Descale if necessary.
• If problem persists, call the Nespresso Club.
31
30.03.20 11:33 30.03.20 11:33