Tabla de contenido
Publicidad
Installation
The QuickScan
The following figure shows the steps to perform an installation.
Turn off the host computer before connection. Consult the host
terminal's manual if necessary.
5
1. Connect the interface (I/F) cable to the linear imager.
2. Connect the I/F cable to the terminal's communication port.
3. Connect the power cord to the I/F cable connector if
required. Linear imagers that use power off the terminal
(P.O.T.) do not require a power supply.
4. If required, connect the AC adapter to the wall outlet.
5. To verify operation, point the linear imager at a bar code and
pull the trigger. The linear imager should emit a single beep
indicating that the label has been scanned successfully.
The linear imager installation is complete.
Power Supply
Unit requires either a Listed Class 2 or Listed LPS power source
which supplies power directly to the linear imager.
Quick Reference Guide
®
QS6500 linear imager is easy to install and use.
1
2
3
$4.50
$2.79
$3.99
4
1
Publicidad
Tabla de contenido
