Preparing The Remote Control - Progress Lighting AirPro P250003 Manual De Instalación

Preparing the Remote
Control
NOTE: The remote control has already
been paired to the ceiling fan for your
convenience. If you have two of the
same model fans in your home , please
follow the steps below to control each fan
independently.
1. Remove the battery cover by pressing
firmly on the arrow and sliding the cover
off.
2. Install two 1.5V AAA batteries (N)
(included).
3. Slide the dip switch in the battery
compartment to the "1" setting.
4. Confirm that the power to the fan is off at
either the wall switch or breaker box.
5. Return power to the fan at the wall switch
or breaker box.
6. Press and release the "Learn" button located
in the remote's battery compartment within
30 seconds of turning on the power.
7. If pairing is successful, the fan's light kit
will flash and the blades will begin to spin.
8. Replace the battery cover on the remote
control.
LEARN
LEARN
Figure 20
Mounting the Remote Control Holder
NOTE: Screw wall anchors are included for extra support. The
included screws are designed to screw easily into the wall. If
you would like a more permanent or secure hold, install the wall
anchors prior to attaching the wall cradle to the wall.
□
Position the wall cradle in the desired position and attach it to
the wall using the included wall cradle screws.
10. Remote Control