Attaching The Fan Blades - Progress Lighting AirPro P250003 Manual De Instalación

Attaching the Fan Blades

1. Put the fan upside down as shown. Attach
the blades to the fan motor assembly by
aligning the notches on the blades with
alignment post on the flywheel and put
the blade on to the flywheel, secure with
screws and tighten it.
2. Repeat these steps for remaining blades.
(Figure 5)
3. Flip the fan right side up as shown.
Tighten the blades to the flywheel by
installing the screws to the side of
flywheel. (Figure 6)
4. Make sure all the screws are firmly
tightened. (Figure 6)
Bottom of
Screws
fan motor assembly
Top of fan
motor assembly
Screws
Motor Assembly
Attaching the Decorative
Blade
Ring
1. Remove the three screws from the tab of
fan-motor assembly. Attach the decorative
ring to the fan -motor assembly by
aligning the holes on decorative ring
with the holes on the tab, and install the
screws.
2. Make sure all the screws are firmly
tightened. (Figure 7)
Figure 5
Motor Assembly
Blade
Figure 6
Screws
Decorative
Ring
Figure 7 4.