Hanging The Fan - Progress Lighting AirPro P250003 Manual De Instalación

Hanging the Fan

REMEMBER to turn off the power. Follow
the steps below to hang your fan properly.
NOTE: This fan is recommended for
standard ceiling mount using the downrod
provided with this fan. When using standard
ceiling fan installation with the 6 inch
downrod provided, the distance from the
ceiling to the bottom of the fan blades will be
approximately 13 inches.
Standard Ceiling Mounting
1. Remove the canopy ring from the canopy
by turning the ring to the right until it
unlocks. (Figure 8)
2. Remove the mounting plate from the
canopy by loosening the four screws on
the top of the canopy. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove
the mounting plate. (Figure 9)
3. Remove the hanger pin and locking pin
from downrod assembly.
4. Route the wires exiting the top of the fan
motor through the decorative motor collar
cover then the canopy ring. Make sure the
slot openings are on top. Route the wires
through the canopy and then through the
ball/downrod assembly. (Figure 10)
5. Loosen, but do not remove, the set screws
on the collar on the top of the motor
housing.
5.
6. Align the holes at the bottom of the
downrod with the holes in the collar on
top of the motor housing. (Figure 10 )
7. Carefully insert the hanger pin through
the holes in the collar and downrod. Be
careful not to jam the hanger pin against
the wiring inside the downrod. Insert the
locking pin through the hole near the end
of the bolt until it snaps into its locked
position, as noted in the circle inset of
Figure 10.
8. Re-tighten the set screws on the collar on
top of the motor housing.
9. Make sure the grommet is properly
installed in the collar cover, then slide
the collar cover on the downrod until it
rests on the motor housing. Be sure that
the canopy and the collar cover are both
oriented correctly.
10. Proceed to "Installing the Fan" section.
FAILURE TO PROPERLY INSTALL SET SCREWS
AS NOTED IN STEP 8 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Turn Canopy to Remove
Loosen but Do Not Remove
Remove
Motor wires
Ball/Downrod
assembly
Canopy
Canopy ring
Motor collar
cover
Hanger pin
Motor collar
Figure 8
Figure 9
Pin in locked
position
Locking pin
Tighten
screws
Figure 10