Hard Disk Installation - Avtech AVH800A6 Manual Del Usuario

HARD DISK INSTALLATION

This NVR supports both 2.5" and 3.5" hard disk drives based on your demands. Please follow the instructions below to
install a hard disk in the NVR.
To install a 3.5" hard disk
Step1: Turn the NVR bottom side facing you, and remove the four screws.
Step2: Turn the NVR rear panel facing you, and slightly push the case upward to remove it, as shown below.
Step3: Get a compatible hard disk. With the PCB side facing down, insert the hard disk to one of the hard disk
connector.
Step4: To fix the hard disk, please fasten it to the bracket with the supplied screws.
Step5: Replace the upper cover back to the NVR.
Step6: Replace and fasten the screws loosened in Step1 to the NVR.
037Z
1