Össur REBOUND DUAL Instrucciones Para El Uso página 8

Adjusting f it at the tibia:
The tibial pad can be installed to fill in any gaps around the tibia and
achieve the desired fit. To add the tibial pad, pull back the lower liner and
place the tibial pad on top of the hook-and-loop fastener to which the
lower liner was originally fastened. Press the lower liner back into place
on top of the pad. Adjust the padding until the Rebound DUAL brace fits
snugly against the tibia.
Changing Extension Stops
Extension stops are available for varying degrees of extension control.
1. Remove the pad from the condylar area.
2. Use a short Philips head screwdriver and remove the retaining screw.
3. Slide the 0° stop out of the hinge.
4. Insert desired extension stop.
5. Secure with retaining screw (DO NOT OVER TIGHTEN)
6. Repeat on the other hinge.
7. To add flexion stop: follow steps 1, insert desired flexion stop, and
then follow steps 5–6.
LIMITED WARRANTY
This warranty covers all defects in materials and workmanship of your
new Rebound DUAL Knee Brace. This warranty covers the frame and
hinges for 2 years, and custom warranty is lifetime. The warranty covers
all other materials, including straps, sleeves, liners and pads for six
months from the date of original purchase.
Össur will repair or replace (at its option) any defective part covered
under warranty at no charge. Repairs necessitated by accident,
negligence, misuse or abuse by the purchaser are not covered. Also,
consequential and incidental damages are not recoverable under this
warranty. These limitations may not apply as some states do not allow
the exclusion or limitation of incidental or consequential damages. Only
the original purchaser is entitled to claim service under this warranty.
To obtain service under this warranty call our Customer Service
Department.
8