Dune HD Duo 4K Manual De Instrucciones página 10

DUNE HD DUO 4K
If you see «DUNE HD» logo on the TV screen when you switch on the player,
but then the picture disappears and the other picture does not appear during at
least 10 seconds, it may mean that a wrong video output mode is configured in
the player. In this case, press the «MODE» RC button, and then press one of
the RC buttons «1», «2», «3», «4» or «5» to switch to a different video output
mode (see «Quick Setting of Video Output Mode» for more information).
Finally, you should see the initial setup wizard, which will allow you to perform
the initial player configuration. After that you should see the main screen of
the player menu. The main screen shows menu items which allow the use of
different player functions and access to all storage devices and network drives
connected to the player.
Adjust the player settings as needed using «Setup» menu.
Quick Setting of Video Output Mode
The "MODE" RC button allows quick setting of video output mode without
entering the player setup menu. This way of video output configuration may
be required if you see no picture on the screen after connecting your player to
a TV.
Press the "MODE" RC button and then one of the RC buttons "1", "2", "3", "4",
or "5" to switch to one of the following video output modes respectively:
1. Composite PAL
2. Composite NTSC
3. HDMI, 480i, 60 Hz
4. HDMI, 720p, 60 Hz
5. HDMI, 1080i, 60 Hz
After you see a picture on the TV screen, press the "ENTER" RC button, and
then go to the player setup menu to perform a more precise configuration of
the video output mode if needed.
NOTE: The procedure of quick setting of video output mode cannot be used
during playback and in some other cases. To ensure this procedure can be
used, switch the player off, then switch the player on, and then wait about 1
minute to ensure the player loading is finished. After that press the «STOP»
10