Automatic Shutoff - Hamilton Beach Smart Lift 14401 Manual De Instrucciones

840174302 ENnv01.qxd:Layout 1
To Dry Iron
1
5
Pull Smart Lift Trigger to activate.
4
9/10/09 10:11 AM Page 4

AUTOMATIC SHUTOFF:

Your iron is equipped with a feature which can be used to turn off iron heat when iron is not in use (see
chart below). On certain models, this auto shutoff feature will only activate when the AUTO OFF/STAY ON Switch is in the "AUTO OFF"
position. If the iron turns off automatically, it will begin to heat again when the iron is moved. NOTE: If you wish to deactivate this
feature, slide the switch to the "STAY ON" position. The iron will then stay in the heating mode until turned OFF or unplugged.
Iron Position
Face Down (soleplate touching any surface or if tipped over/fallen on side)
Upright (resting on heel or Smart Lift feature)
2
The AUTO OFF/STAY ON Switch is an
optional feature on select models only.
6
Iron will rest securely on Smart Lift™
feature.
Auto Standby
30 seconds
15 minutes
3
Set Adjustable Steam Lever to OFF. Turn
Temperature Control Dial to desired tem-
perature. See Fabric Setting Chart.
7
Press down on iron to deactivate Smart
Lift feature and resume ironing.
4
Allow 2 minutes for iron to reach desired
temperature before using. NOTE: To avoid
property damage to supporting surfaces,
always use an ironing board.
8
When finished, turn Temperature Control
Dial to OFF and unplug iron.