Using The Machine - CombiSteel 7075 Serie ENT VL-VLA-VLC 230 Manual Del Usuario

7. USING THE MACHINE

ATTENTION: In that position, when the dial is turned to P1, that will start the washing, however the detergent
foams because the cold water. For the best result of the washing process, the signal lamp of "the washing
temperature is ready" should be waiting.
1. READY
2. ON/OFF
3. P1 : 1. short program 80 sec
4. P2 : 2. medium program 110 sec
5. P3 : 3. long program 140 sec
6. DRAIN

P1-Short Wash (80 sec) : For dishes with low dirt

P2-Medium Wash (110 sec) : For dirty dishes

P3-Long wash (140-180 sec.) : For oily and dirty dishes
You can select one of the programs "P1, P2 and P3". Recommended washing duration is 110 sec. and
recommended water temperature is 55ºC. At the start of operation, when the temperature reaches 55ºC,
"washing temperature reached signal light" turns on. After the light turns on, an appropriate program is selected.
As long as the washing continues, the "in wash" signal light stays on.
DRAINING:
You have to turn the program switch to drain position. When the device is on and in standby state, remove the
fuse in the tank and press and hold the "Drain Button". Drain button light turns on, indicating that the process is
done. When you are sure that the water drained completely, turn off the machine. The full model includes a top
level pressure stat. When the water level reaches above the spill level, the bilge pump runs and automatically
drains for a certain amount of time. This running continues until the contacts of the pressure stat relocates.
MANUAL DISCHARGE:
When the device is on or in standby mode, plastic plug in the tank is removed and DISCHARGE button is pressed
during 2 seconds. Discharge button blinks, which is a sign that the process has started. When the process is over,
the device shuts off automatically (it goes into OFF mode.) When the water exceeds the overflow level, the drain
pump starts to work and the automatic drainage works for a length of time. In this way, the water level is
maintained.
1. An integrated dish washing system can be formed in the device by installing units such as; scraping unit, dust
cart, bench with sink support and output bench.
2. For the washing process in the device, use liquid and foam free detergent. Amount to be used must be
determined by the detergent manufacturer. Also, the amount of polisher to be used must be determined by
the manufacturer firm. Detergent and polisher placement units are also made by the manufacturer firms.
3. Select the most suitable program according to the type and/or dirtiness of the dishes to be washed.
4. Select the relevant tray according to the dishes to be washed and load them according to the capacities
stated on the chart. Do not start the device without entirely filling the tray in order to save detergent and
power.
5. An integrated dishwashing system might be installed by mounting the units such as wiper unit, sink shelf
with under-sink bin and output dish table on the machine (for 102S).
6. Never change the location of the device while it is operating.
7. Be sure that the water input valve is open before operating the device.
WARNING!!!
NEVER PUT YOUR BARE HANDS IN THE WASH WATER. IF NECESSARY, USE PROTECTIVE GLOVES. DO NOT RUB
DETERGENT WATER ON YOUR EYES.
www.combisteel.com
7