Upright SL26 Manual Del Operador página 6

Fold Down Guardrails
This procedure is only for passing through door-
ways. Guardrails must be returned to proper
position before using the machine.
Fold Down Procedure (Figure 4)
Note: When performing the following proce-
dures retain all fasteners.
1. Place controller on platform.
2. Starting at the front of platform, remove nuts,
bolts and washers from the top of front guardrail.
Fold front guardrail down onto the platform.
3. Close and latch the gate.
4. Remove hardware from top of rear guardrail.
Fold rear guardrail down onto platform being
careful to keep gate latched at all times.
5. Remove nuts, bolts and washers from top of
side guardrails and from slideout deck midrail.
Lift up and fold one side guardrail in so it rests
on the deck. Repeat with other side guardrails.
Erection Procedure
1. Raise side guardrails making sure each is
pushed down to secure the guardrail in the
vertical position.
2. Install bolts, washers and nuts between the side
guardrails, tighten securely.
3. Raise rear guardrail assembly, aligning holes
and install bolts, washers and nuts. Tighten
securely.
4. Raise front guardrail, aligning holes and install
bolts, washers and nuts. Tighten securely.
5. Hang controller from front guardrail.
6. Before operating work platform check that all
fasteners are in place and properly torqued.
Before entering Platform, guardrails must be
securely fastened in their proper position.
Figure 4: Fold Down Guardrails
Transporting Work Platform
By Forklift
Note: Forklifting is for transporting only.
See specifications for weight of work platform
and be certain that forklift is of adequate
capacity to lift platform.
Forklift from side of Chassis by lifting under the
Chassis Modules (Figure 5).
By Crane
Secure straps to Chassis Lifting Lugs only (Figure 5).
By Truck
1. Manoeuvre the work platform into transport
position and chock wheels.
2. Secure the work platform to the transport
vehicle with chains or straps of adequate load
capacity attached to the chassis tie down lugs
(Figure 5).
Tie down lugs are not to be used to lift work
platform.
Over-tightening of chains or straps through
tie down lugs may result in damage to work
platform.
Front Tie
Downs/
Lifting Lugs
Forklift
Figure 5: Transporting Work Platform
6
Rear Lifting
Lug
(Typical)
Rear Tie
Downs