Weston 65-0501-W Manual Del Usuario página 4

REPLACING THE VACUUM
Plastic Lid Base
CHAMBER LID SEAL:
Vacuum
1. Press the ON/OFF Button on the Control
Chamber
Panel to turn the Vacuum Sealer "OFF".
Lid Seal
Figure 3
2. Disconnect the Vacuum Sealer from the
power supply.
3. Make sure the Vacuum Sealer is
completely cool.
4. Press both of the Lid Release Buttons
on each side of the Vacuum Sealer to
release the lid lock, then lift the Vacuum
Lid to open.
5. Remove the Vacuum Chamber Lid
Seal from the groove in the Plastic Lid
Base (Figure 3).
NOTE:
The Vacuum Chamber Lid Seal
has an adhesive backing-if the adhesive
does not remove cleanly from the plastic,
use a gentle, household adhesive remover.
Make sure the surface is dry and oil free
before replacing with the new Vacuum
Chamber Lid Seal.
6. Peel off the backing from the Vacuum
Chamber Lid Seal. Position the new
Vacuum Chamber Lid Seal into the groove
in the Plastic Lid Base.
7. Work the Vacuum Chamber Lid Seal
into the groove with your fingers until the
seal is completely in place and hold for 30
seconds. Wait for 30 minutes before using.
-4-