Weston 65-0501-W Manual Del Usuario página 6

REPLACING THE SEAL BAR TAPE:
1. Press the ON/OFF Button on the
Control Panel to turn the Vacuum Sealer
"OFF".
2. Disconnect the Vacuum Sealer from the
power supply.
3. Make sure the Vacuum Sealer is
completely cool.
4. Pick at either end of the Seal Bar
Tape covering the Seal Bar Heating
Element until it lifts slightly (Figure 6).
Grasp the loose end and slowly pull
the Seal Bar Tape back over itself until fully
removed.
5. Remove the backing from a new strip of Seal Bar Tape. Be careful not to allow the
Seal Bar Tape to contact anything including itself while the adhesive side is exposed.
6. Hold one end of the Seal Bar Tape in each hand. Stick the left end of the Seal Bar
Tape to the flat area on the Base just left of the Seal Bar Heating Element. Apply the
Seal Bar Tape from left to right over the Seal Bar Heating Element. Make sure there
are no wrinkles or folds in the Seal Bar Tape once applied. The Seal Bar Tape should
fully cover the Seal Bar Heating Element.
Seal Bar Heating
Element
-6-
Figure 6
Seal Bar Tape