Set-Up Of Operational Parameters - V2 JEDI-L Manual Del Usuario

SET-UP OF OPERATIONAL
PARAMETERS
+ -
1.
2.
0 0
PLEASE NOTE: if programming is not
completed (by means of function 9.
End programming) the parameters set are lost.
If there is an error in the set parameters, simply
power off the device, restore power and then
repeat the programming operation.
1. Setting the open limit switch
I I
I I
+
-
PLEASE NOTE: The open limit switch must be stored prior to the close limit switch. If this
procedure is used erroneously to set the close limit switch, the parameter is NOT stored.
2. Setting the close limit switch
-
2 2
2 2
+
-
17