Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
04 | OPERATION
04.1 Mounting on light stand
Mount the continuous light on a light stand (optionally available from DÖRR) as described below.
Only with SET article no. 373513:
Pull the tripod legs down until the centre struts (20d) are approximately horizontal. Tighten the locking screw (20c).
Slightly loosen the locking screws (20b) to adjust the lamp stand with the 3 extensions to the desired height. Tighten the locking
screws (20b) again.
Screw the locking screw (06) all the way in and place the light stand holder (07) on the threaded spigot (20a).
ATTENTION:
To avoid tilting of the LED light, align the light surface of the continuous light over a wide tripod leg.
Tighten the locking screws (06) again.
Loosen the side locking screws (04) on the swivelling bracket (05) to align the continuous light. Tighten the locking screws (04) again.
ATTENTION:
To align the continuous light during operation, touch the continuous light only on the two handles (08).
04.2 Removing/attaching the diffuser panel
To remove the diffuser panel, press the release button (03) down and slide the panel out of the guide rails to the right.
To refit the diffuser panel, make sure that the panel is inserted in the upper and lower guide rails. Slide the panel to the left until the
release button (03) sticks out completely again. You may have to lift the panel slightly on the left-hand side to be able to push the
panel in as far as it will go.
14
doerr-foto.de
Publicidad
Tabla de contenido
