Klimatronic Heat Supreme 2000 Manual Del Usuario página 17

make sure the appliance's on/off switch (at the left
side) is turned off.
• In humid rooms, the power cord must be at least 25
cm above the ground. Make sure the cord doesn't
touch neither the ground nor hot parts of the heater.
• The power outlet where the appliance's power cord
is connected should be placed so that it is visible
and easily accessible to the user.
• This appliance must not be installed in an enclosed
place where air cannot circulate freely
Warning: In order to avoid overheating, do
not cover the heater!
Assembly
Please remove all packaging materials and check all components for visible damage. In the event of damage,
please do not proceed with the assembly and contact your point of sale. The following assembly steps refer to
the figures at the beginning of this manual.
1. Select a wall that is suitable for installing the appliance. The wall must be stable, straight and not be
made of flammable material, e.g. wood or plastic. The min. distances as shown in fig.1 must be followed.
2. Use the enclosed template to mark the holes to be drilled on the wall. Please make sure that the
markings are straight (see fig.2a). Drill four holes with a diameter of 6mm each into the wall (see fig.2b).
3. Please insert one peg per hole into the wall and push them in with a hammer until the pegs no longer
stick out from the wall (see fig.3).
4. Fix the wall bracket to the two upper holes using two ST4x35 screws (see fig.4).
5. Fasten the two z-brackets to the back of the unit using two M4x8 screws. Insert the smaller towel rail
into the provided brackets and screw it tight with four M4x16 screws. Repeat the procedure with the
larger towel rail and four additional M4x16 screws (see fig.5). The towel rails are height adjustable even
after assembly. To do so, slide the towel rails up or down into the desired positions.
6. Two persons are required for the following assembly step: Place the appliance on the wall bracket and
fasten it on the left and right side with two M4x10 screws each to the wall bracket (see fig.6).
7. Please fix the z-brackets to the wall using two ST4x35 screws. The screws should fit into the two
previously drilled lower holes (see fig. 7).
8. Wipe the surface of the appliance with a soft cloth (see fig. 8). The appliance is ready for operation.
Operation
•
Operating voltage: 230-240V~, 50Hz, 2000W
•
Control panel:
Display
Value increase
Week program setting
Confirmation
Setting
On/Off
Selection heating power/fan
Open window sensor/
towel warming function
Value decrease