Publicidad
Idiomas disponibles
Idiomas disponibles
•
Connect the appliance to the power supply and push the on/off switch (O/I) located at the left side of the
heater to switch on the appliance. An acoustic signal sounds and the display will light up for 3 seconds,
then automatically switch to standby mode. Push the on/off switch again when you want to switch it off.
Note: You can identify the standby mode by a display that does not show any indicating lights for the
heating power/fan (
•
Day and time setting:
In standby mode, press the button „SET". The display shows the days of the week as numbers:
o
1 2 3 4 5 6 7
Use the buttons „+" and „-" to choose between the numbers. The selected day flashes. Please
press „OK" to confirm.
Example: Monday -> 1
After confirming the day, the hour indication of the clock flashes:
o
Use the buttons „+" and „-" to set the current hour and confirm with „OK". Next, the minute
indication flashes:
The display now shows the time and current day of the week.
o
•
Manual operation:
Press the on/off button
o
Temperature setting:
o
▪
Press „SET". The default temperature of 20°C flashes.
▪
Use „+" and „-" to choose a target temperature from 5-40°C. Confirm with „OK".
Note: Heating is stopped when the ambient temperature has reached the target
temperature. If the ambient temperature is 2°C lower than the target temperature,
heating will resume. If the ambient temperature is higher than the target temperature,
no heating is started.
Selection of heating power/fan:
o
▪
Press the button
1800W (
900W (
Cooling fan (
The corresponding indicating light appears on the display. Please note that the fan is
independent from the target and ambient temperature.
Open window sensor:
o
▪
You can activate the open window sensor to prevent the appliance from heating for a
longer period when a window is open. Please note that the sensor can only be used in
the manual operation. To activate the sensor, press and hold the according button for
three seconds.
▪
If the ambient temperature drops by 5°C within 10 minutes, the appliance starts a 30-
min.-countdown:
▪
Press and hold the open window sensor button again for three seconds to deactivate
the sensor.
•
Automatic operation (week program):
In the automatic operation you can set a week program to define on which days, at which times
o
and to which target temperature heating shall take place. During the week program the
appliance works with 1800W (
Week program setting:
o
▪
In standby mode press and hold the week program button for three seconds. The
indicating light
▪
The days of the week appear on the display as numbers.: 1 2 3 4 5 6 7.
Use the buttons „+" and „-" to choose between the numbers. The selected day flashes.
Press „OK" to confirm.
▪
You will now enter the hour setting for your selected day. The appliance can be
programmed between 0-24h for full hours. The hours are indicated by boxes. Each box
represents one hour:
The first box „0" represents the time 00:00 – 00:59 AM, the second box „1" the time
01:00 – 01:59 AM etc.
The selected box flashes quickly. To modify the box, press „SET". Now the box flashes
▪
/
/
).
. Set the current minutes and confirm with „OK".
on the control panel. The manual operation starts with 1800W (
. You may choose between the following modes:
)
)
)
•
After 30 minutes, if the ambient temperature is the same or lower, the appliance
switches to standby mode and the heating as well as open window sensor are
automatically deactivated.
•
If the ambient temperature is higher, the appliance continues to heat and the
open window sensor remains active.
). Other selections are not possible.
flashes until the setting is finished.
).
Publicidad
