Mounting; Electrical Installation - SICK GTB2 Flat Manual De Operación

5

MOUNTING

5 Mounting
6

Electrical installation

6
LED indicator green: supply voltage active
1
LED indicator yellow: status of received light beam
2
Mount the sensor using a suitable mounting bracket (see the SICK range of acces‐
sories).
Note the sensor's maximum permissible tightening torque of 0.1 Nm.
Note the preferred direction of the object relative to the sensor, cf.
drawing", page 11.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Plug connection: note pin assignment: when the lid is open, the male connector
can be swiveled horizontally and vertically.
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanation of the connection diagram (Tables pin assignment):
Q = switching outputs
n. c. = not connected
DC: 10 ... 30 V DC
Table 1: Pin assignment
1
2
3
4
> 0 V) once all electrical connec‐
V
BN + (L+)
- -
BU - (M)
BK Q
BK: 0.1 mm , AWG30
2
BU+BN: 0.127 mm 2 , AWG28
see "Dimensional
= 0 V). The following informa‐
V
+ (L+)
-
- (M)
Q
2 4
3
1
8023328.18HX | SICK
Subject to change without notice