Parts Supplied - Teuco RA33 Instrucciones De Montaje

For the purposes of guarantee validity, the product must be installed as supplied by Teuco.
GB
It is necessary to follow the assembly instructions and only to use the recommended materials and
equipment and the accessories supplied with the product.
This manual is an integral part of the product and therefore, it must be kept in a safe place for future
use, if necessary.
The data and characteristics indicated are in no way binding for Teuco Guzzini Spa, which reserves
the right to make any changes it deems fit without any obligation to give prior warning or supply
replacements.
This product has been devised for residential use only. In the event of public use, it is necessary to
guarantee full compliance with specific legislation and standards as well as with the technical and
safety requirements foreseen by Teuco.
The fitter/owner is responsible for checking and adhering to specific local instructions prior to
installation.
All measurements on the figures in this manual are given in millimetres (mm).
1

PARTS SUPPLIED:

The following section describes the parts supplied for the
use and operation of the ceiling shower head:
•
1 ceiling shower head
•
2 M6 x 50 screws
•
2 M6 x 150 screws (for temporary fastening)
•
1 support frame
•
2 chrome-plated finishing plugs
2
INSTALLATION:
The following section illustrates the process for installing
the ceiling shower head:
•
FITTING THE SUPPORT FRAME
- Make a cavity in the ceiling, as illustrated in Figure 2.
- Inside the cavity, prepare fastenings to secure the
frame to the ceiling or to another structure using
the holes in the frame itself and fastenings that are
capable of supporting the weight of the shower head.
- Insert the frame inside the cavity, making sure that the
horizontal tracks "A" on the frame remain in position
along the outer edge of the cavity itself.
•
CONNECTING THE PIPES
- Attach the ceiling shower head to the frame with the
two M6 x 150 screws, as illustrated in Figure 5.
- Connect the pipes of the shower head to the ceiling
using the piping from the system. One pipe will supply
water for delivery through the central blade, while the
other will supply the perimeter shower heads.
- Test the water flow.
•
FITTING THE SHOWER HEAD TO THE
CEILING
- Unscrew and, one at a time, replace the check screws
with the 2 M6 x 50 screws supplied, as illustrated in
Figure 6.
•
FINISHING THE WATER OUTLET
- Fit the two finishing plugs supplied over the slots for
the fastening screws and secure them with a very
small amount of silicone.
9