Makita BJS130 Manual De Instrucciones página 6

Replacing cutting head for capacity of
gauge 16 (Optional Accessory)
1. Remove the cutting head. (Refer to the section
titled " Removing cutting head ".)
009050
2. Loosen the bearing assembly with provided
wrench while keeping the spindle still by grabbing
the two flat parts on the spindle still with another
wrench.
009051
3. Remove the bearing assmbly (thin one) and
screw the bearing assembly for gauge 16 onto the
spindle and firmly tighten it with the provided
wrench while keeping the spindle still by placing
another wrench on the two flat surface on the
spindle.
4. Install the optional cutting head by referring to the
section titled " Installing cutting head ".
CAUTION:
Do not confound the bearing assembly provided
•
on the tool (thin one) with that for cutting head for
capacity of gauge 16 (Optional Accessory). The
bearing assembly
while that for cutting head for capacity of gauge
16 (Optional Accessory) is thick.
provided on the tool is thin
Hex wrench storage
009021
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow (1)
and raise it in the direction of the arrow (2).
1
2
1
1
009015
OPERATION
009020
1
2
3
009018
6
1. Hex wrench
1
1. Hook
1. Side blade
2. Side blade
surface
3. Center blade
4. Workpiece
4