Technical Specifications - VONROC OT502AC Traducción Del Manual Original

EN

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
No-load speed
Weight
Sound pressure (Lpa)
Acoustic power (Lwa)
Uncertainty (K)
Vibration (sawing in steel)
Uncertainty (K)
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardised test given in EN 60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keep-
ing your hands warm, and organizing your work
patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. On/off switch
2. Speed adjustment wheel
3. Mounting point for accessories
4. Grip
5. Quick change lever
6. Carbon brush cover
6
OT502AC / S_OT502AC
220-240 V
50 Hz
300 W
0-23.000 /min
1.21 kg
85 dB(A)
96 dB(A)
3 dB(A)
7.28 m/s
2
1.5 m/s
2
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
The sanding pad and the sanding paper must be
used for sanding applications.
Removing and mouting accessories (fig. B)
• Release the quick change lever (5) and slide the
accessory forward to remove from the holder.
• Slide the accessory in the holder and fasten the
quick change lever (5).
4. OPERATION
Switching on and off (fig. A)
• To switch on the machine, slide the on/off
switch (1) to the front.
• To switch off the machine, slide the on/off
switch (1) to the rear.
Setting the speed (fig. A)
The speed adjustment wheel is used for setting the
speed. The speed adjustment wheel can be set to 6
positions. The ideal speed depends on the applica-
tion and on the material to be worked.
Do not set the speed during use.
• Turn the speed adjustment wheel (2) to the
required position.
Hints for optimum use
• Clamp the workpiece. Use a clamping device for
small workpieces.
• Draw a line to define the direction in which to
guide the accessory.
• Firmly hold the machine by the grip.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the accessory on the workpiece.
• Slowly move the machine along the pre-drawn
line, firmly pressing the accessory against the
workpiece.
• Do not apply too much pressure on the ma-
chine. Let the machine do the work.
• Switch off the machine and wait for the ma-
chine to come to a complete standstill before
putting the machine down.
WWW.VONROC.COM