Tabla de contenido
Publicidad
Removing
• Place the machine on a table with the mounting
point (3) facing upwards.
• Loosen the Allen screw (7) using the Allen key (5).
• Remove the spacer (8).
• Remove the saw blade (11) from the mounting
point (3).
• Mount the spacer (8).
• Tighten the Allen screw (7) using the Allen key (5).
Mounting and removing the scraping knife (fig. B)
The scraping knife must be used for scraping
applications.
Mounting
• Place the machine on a table with the mounting
point (3) facing upwards.
• Loosen the Allen screw (7) using the Allen key (5).
• Remove the spacer (8).
• Mount the scraping knife (12) to the mounting
point (3).
• Mount the spacer (8).
• Tighten the Allen screw (7) using the Allen key (5).
Removing
• Place the machine on a table with the mounting
point (3) facing upwards.
• Loosen the Allen screw (7) using the Allen key (5).
• Remove the spacer (8).
• Remove the scraping knife (12) from the mounting
point (3).
• Mount the spacer (8).
• Tighten the Allen screw (7) using the Allen key (5).
USE
Switching on and off (fig. A)
• To switch on the machine, slide the on/off
switch (1) to the front.
• To switch off the machine, slide the on/off
switch (1) to the rear.
Setting the speed (fig. A)
The speed adjustment wheel is used for setting
the speed. The speed adjustment wheel can be
set to 6 positions.
The ideal speed depends on the application and
on the material to be worked.
Do not set the speed during use.
• Turn the speed adjustment wheel (2) to the
required position.
Hints for optimum use
• Clamp the workpiece. Use a clamping device
for small workpieces.
• Draw a line to define the direction in which to
guide the accessory.
• Firmly hold the machine by the grip.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the accessory on the workpiece.
• Slowly move the machine along the pre-drawn
line, firmly pressing the accessory against the
workpiece.
• Do not apply too much pressure on the machine.
Let the machine do the work.
• Switch off the machine and wait for the machine
to come to a complete standstill before putting
the machine down.
CLEANING AND MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
• Regularly clean the housing with a soft cloth.
• Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
Replacing the accessories (fig. B)
Worn or damaged accessories must be replaced
immediately.
Only use sharp and undamaged
accessories.
• To remove the accessory, proceed as described
in the corresponding section.
• To mount the accessory, proceed as described
in the corresponding section.
7
Publicidad
Tabla de contenido
