Preparing A New Sprayer - Titan SPEEFLO PowrLiner 2850 Manual Del Propietário

Ocultar thumbs Ver también para SPEEFLO PowrLiner 2850:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Trigger Selector (Two-Gun units)
1. Set the trigger selector for proper spray gun operation.
The gun lever on the right handlebar triggers the gun or
guns. The selector on the trigger must be set for the first
gun, both guns, or the second gun .
IMPORTaNT: always turn the trigger lock on the spray gun
to the locked position before making any adjustments to the
trigger selector. also, release the trigger cable from its block
by lifting the cable up and out of the block. There will be a
brief triggering of the gun while releasing the trigger cable.
a. First Gun — The first
gun position is with
the selector in the left
position. Push the lever
toward the inside of
the frame until the pin
engages the left plate.
b. Both Guns — The dual
gun position is with the
selector in the center
position. Push the
lever toward the center
position until the pin
engages both plates.
The pin must engage
both plates.
c. Second Gun — The
second gun position is
with the selector in the
right position. Push
the lever away from the
inside of the frame until
the pin engages the right
plate.
English

Preparing a New Sprayer

If this unit is new, it is shipped with test fluid in the fluid section
to prevent corrosion during shipment and storage. This fluid
must be thoroughly cleaned out of the system with mineral spirits
before you begin spraying.
IMPORTaNT: always keep the trigger
lock on the spray gun in the locked
position while preparing the system.
1. Place the siphon tube into a
container of mineral spirits that has a
flash point of 60ºC (140ºF) or above.
2. Place the return hose into a metal
waste container.
3. Turn the pressure control knob
fully counterclockwise to its lowest
pressure setting.
4. Move the PRIME/SPRAY valve to the
PRIME position.
5. Move the engine ON/OFF switch to
the ON position.
6. Start the engine:
a. Open the fuel valve
lever.
b. Move the throttle
lever away from the
gas tank.
c. Close the engine
choke lever.
d. Holding the frame
with one hand, pull
the starter rope
rapidly and firmly. Continue to hold the rope as you let
it return. Pull and return the rope until the engine starts.
7. Turn on the sprayer by
moving the pump ON/OFF
switch to the ON position.
8. Slowly turn the pressure
control knob clockwise to
increase the pressure until
fluid starts to come out of
the return hose. Use only
enough pressure to keep the
fluid coming out.
9. Allow the sprayer to run for
15–30 seconds to flush the test fluid out through the return
hose and into the waste container.
10. Turn the pressure control knob fully counterclockwise to
its lowest setting.
11. Turn off the sprayer by moving the pump ON/OFF switch
to the OFF position.
6
Trigger lock in
locked position.
PRIME
Throttle
Choke Lever
Lever
Engine
ON/OFF
Switch
Fuel Valve
Lever
Starter Rope
Sprayer
Pressure
ON/OFF
Control
Switch
Knob
© Titan Tool Inc. All rights reserved.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

02900080290025

Tabla de contenido