BH FITNESS G840 Instrucciones De Montaje página 17

9. FITTING THE HANDLEBAR.-
Bring the handlebar (3) up to the
handlebar stem (9), Fig.9, insert the
hand-grip cable (7) in through the slot
as shown in Fig.9, and pull it out
through the top of the handlebar stem.
Refit the screw (91), Fig.9, and tighten
securely, then fit the bracket cover (92).
10.- FITTING THE MONITOR.-
Next, connect terminals, sticking out of
the handlebar, and terminals, sticking
out of the monitor (1), Fig.10.
Place the monitor (1) on top of the plate
on the main post (9), as shown in
Fig.10, making sure not to pinch the
wires.
Use supplied screws to hold the
monitor in place, Fig.10.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This can
be achieved by screwing the adjustable
feet (25) up or down, as shown in
Fig.11.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (15),
as shown in Fig.12, which make it
easier to move. The two wheels at the
front of the unit make it easier to place
the unit in to any chosen position by
lifting the rear slightly
Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack (m) for the transformer
into the connection hole on the main
body (k) (bottom, rear of the machine)
and then plug the transformer (131)
into a 230 V mains supply, Fig.13.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
17