Sanus VISIONMOUNT MF202 Instrucciones De Montaje página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 16
2
Wood Stud Mounting
< 16 mm
(5/8 in.)
[02]
[15]
[14]
6901-002093 <01>
75 mm
3 in.
[02]
[15]
Locate a stud. Verify the center of the stud using an edge to edge
stud fi nder.
CAUTION:
Improper use could reduce the holding
power of the lag bolt. To avoid potential injuries or
property damage:
Any material covering the wall must not exceed 16
mm (5/8 in.).
Minimum wood stud size: common 2 x 4 in. (nominal
1.5 x 3.5 in.)
Level the wall plate [02] and mark the locations.
F
OR ASSITANCE IN DETERMINING WALL PLATE LOCATION
F
INDER AT SANUS
Drill pilot holes as illustrated.
CAUTION:
Improper use could reduce the holding
power of the lag bolt. To avoid potential injuries or property
damage: pilot holes MUST be drilled to a depth of 75 mm (3
in.), using a 5.5 mm (7/32 in.) diameter drill bit.
Place the wall plate against the wall. Tighten the lag bolts
[14] only until the washers [15] are pulled fi rmly against the
wall plate [02].
CAUTION:
Improper use could reduce the holding
power of the lag bolt. To avoid potential injuries or property
damage DO NOT over-tighten the lag bolts [14].
13mm
5.5mm
(1/2 in.)
(7/32 in.)
,
H
SEE
EIGHT
.
.
COM
7

Publicidad

Tabla de contenido
loading

Tabla de contenido