Quantum DDS-4 Instrucciones De Instalación página 7

Figure 7 Mounting Internal
Tape Drive
5 Turn off your computer, remove its covers and power cord, and select a mounting
bay for the drive. Depending on your drive, select a 3.5-inch or 5.25-inch bay.
6 Mount the drive into the bay and secure using the supplied screws.
7 Install the data and power connectors:
Connect a SCSI interface cable to the drive.
a
The internal tape drives can be used with a Wide SCSI interface, either Low
Voltage Differential (LVD) or Single-ended (16-bit Wide mode). The tape drive
automatically detects whether the SCSI bus is LVD or single ended. Be sure the
internal tape drive is not the last device on the SCSI bus (the drive does not
provide SCSI termination); the SCSI bus must be terminated properly.
b Connect a 4-pin power cable from the computer's internal power supply to the
power connector on the back of the internal tape drive.
Internal Tape Drive
DDS-4/DAT 72
7