Installing The Internal Tape; Drivewith A Sata Connector - Quantum DDS-4 Instrucciones De Instalación

Tabletop and Internal Tape Drive Installation
Figure 8 SCSI Termination
Internal Drive
Installing an Internal Tape
Drive with a SATA
Connector
8
SCSI interface connector
Power connector
SCSI terminator
SCSI T e r minato
Tape drive
T ape driv e
(no termination)
(no te r mination )
SCSI device
SCSI d e vi c e
(termination
( te r minatio n
disabled)
disa b led )
SCSI controller
(termination
SCSI Controll e r
(te r mination ena
9 Replace the computer covers and power cord, turn on the computer, and verify that
the internal tape drive is operating properly.
10 Register your tape drive at
To install an internal tape drive with a SATA connector:
1 Unpack the contents of your drive package. If any item is damaged, please contact
0
your place of purchase immediately.
2 In addition to the contents included with your tape drive, you need the following
items:
• A SATA host bus adapter (for SATA drives) that is properly installed and
configured in a host computer
• A 3.5-inch or 5.25-inch half-height bay
• A SATA data cable
SCSI controller
SCSI d e vi c e
r
(termination
( te r minatio n
ena b led )
enabled)
Tape drive
T ape driv e
(no termination)
(no te r mination )
SCSI controller
SCSI Controll e r
enabled)
(te r mination ena
b led )
http://www.quantum.com/registration.
Internal Tape Drive
(termination
enabled)
b led )