Dyna-Glo DGPH301BL Manual Del Propietário página 12

ASSEMBLY INSTRUCTIONS
13. Connect gas hose and regulator to propane cylinder (not
13
included). Do not cross-thread.
I
CONNECTING GAS CYLINDER
The propane cylinder must be constructed and marked in
accordance with the specification for LP gas cylinders of the
U.S. Department of Transportation (DOT) or the standard for
cylinders, spheres and tubes for transportation of dangerous
goods and commission, CAN/CSA-B339.
The cylinder must have a listed overfilling prevention device.
The cylinder must have a connection device compatible with
the connection for the appliance.
The cylinder used must include a collar to protect the cylinder
valve.
Never connect an unregulated propane cylinder to the heater.
Use only 20-pound cylinders (height: 18.11 inches/46CM，
tank diameter: 9.84 inches / 25CM, foot
diameter: 8.03 inches / 20.4CM) equipped with a cylinder
connection device compatible with the connection for outdoor
cooking appliances. The cylinder must include a collar to
protect the cylinder valve. The gas cylinder should not be
dropped or handled roughly!
Manifold Pressure :11.0 in.W.C. / 2.74 kPa.
Maximum Gas Supply Pressure： Bottle pressure.
Minimum Inlet Supply Pressure: 25 psi/175kPa.
Storage of an appliance indoors is permissible only if the
cylinder is disconnected and removed from the appliance.
A cylinder must be stored outdoors in a well-ventilated area
out of the reach of children.
A disconnected cylinder must have dust caps tightly installed
and must not be stored in a building, garage or any other
enclosed area.
A minimum of 17,000 BTU/H / 4.98KW per hour is the
required input rating for a heater with a rating less than full.
The pressure regulator and hose assembly supplied with the
appliance must be used.
The installation must conform with local codes, or in the
absence of local codes,with national fuel gas code, ANSI
Z223.1/NFPA54, natural gas and propane Installation Code,
CSA B149.1, or propane storage and handling code, B149.2.
12