Suspend Mode; Switching Off The M210Se Handheld Terminal - ACD M210SE Manual De Instrucciones

3.2.5 Suspend Mode

In suspend mode, the operating system and the application running on it are stopped. The display is
switched off and consequently becomes dark. Suspend mode can be accessed by pressing the "C" button
an the "F" button, whereby the "C" button must first be pressed and held. Then the "F" button must also be
pressed. Upon leaving suspend mode (switching on the M210SE), the application and the operating system
starts to run from the same point. Thanks to both measures, the M210SE only uses a small amount of
power.
Figure 6: Suspend Mode of the M210SE

3.2.6 Switching off the M210SE Handheld Terminal

The device can be switched off by pressing the "C" button, the top right button and the "F" button whereby
the "C" button must be pressed and held first. Then additionally press the top right button and hold it. Then
additionally press and hold the "F" button (see Figure 7). Hold these three buttons for a minimum of 10
seconds!
Figure 7: Switching off the M210SE
M210SE_Lidl_Brief_Overview_FCC_V1.04_en_es.doc 10 / 32