Status Of The Ds210 Docking Station Leds - ACD M210SE Manual De Instrucciones

3.2.7 Status of the DS210 Docking Station LEDs

The DS210 status LEDs are located on the front of the docking station.
Figure 8: Status of the DS210 LEDs
The POWER LED shows a green light as soon as the DS210 is supplied with current via the power supply
unit.
The CHARGE LED shows a red light when the M210 is charging. The LED shows a green light once the
M210SE is fully charged. In order to ensure a correct display, the M210SE must be switched off. If the
M210SE is switched on, the CHARGE LED may show a red light although the battery is already charged.
The 2. BATTERY LED shows a red light if a spare battery is being charged. The LED shows a green light
once the spare battery is fully charged.
With the DS210 Ethernet, the CONNECT LED flashes green if the DS210 is connected to the LAN (Ethernet)
with a network cable and the M210SE has loaded the Ethernet driver. Therefore, the CONNECT-LED has
the same function as the green Link LED on the network socket (RJ45 with two integrated LEDs) on the rear
end of the device. The yellow LED is the Tx LED. It flashes if data is being transmitted from the M210SE into
the LAN via the DS210.
Tx LED
Power
Supply
Figure 9: RJ45 connector with LEDs
ATTENTION
M210SE_Lidl_Brief_Overview_FCC_V1.04_en_es.doc
Link LED
Unintended use of the interfaces should be avoided.
11 / 32