Cleaning And Maintenance Information; Display; Charging And Communication Contacts; Scanner, Camera And Camera Light Window - ACD M210SE Manual De Instrucciones

4 Cleaning and Maintenance Information

ATTENTION
ATTENTION
Clean the device when dirty and by placing it firmly onto a surface (e.g. table). This ensures a secure hold
and the device cannot slip out of your hand during the cleaning process.

4.1 Display

Clean the display with a soft, dry cloth. In order to do, always switch off the device as the display responds to
all contact and could therefore compromise or interfere with the active program. Do not apply any severe
pressure on the display.

4.2 Charging and Communication Contacts

If transfer problems occur, clean the charging and communication contacts with a soft, moist cloth.
When dealing with the DS210, the power plug must be disconnected beforehand.

4.3 Scanner, Camera and Camera light window

In the event of any irregularities during scanning, switch off the device and clean the scanner window with a
soft, dry cloth. The scanner window is ultra-transparent and can hardly be seen with the naked eye. Carefully
clean the window without applying excess force on the glass.
M210SE_Lidl_Brief_Overview_FCC_V1.04_en_es.doc
Turn off the device before starting any cleaning or maintenance
process!
Make sure that the laser beam is switched off by checking the
laser beam exit!
Do not use any corrosive chemicals, cleaning solutions or strong
cleaning agents in order to clean the device.
All components must be disposed of properly at the end of their
technical lifetime.
Laser beam exit
12 / 32