Publicidad
Idiomas disponibles
Idiomas disponibles
Important note: You may use your wet/dry filter as a con-
tinuous-flow filter for the short-term treatment with medi-
cation and its consequent removal. Extract filter media from
the canister and store it in a
basin with tank water, and
fill the filter entirely with EH-
FISYNTH or filter wadding.
Close the breather pipe with
a pipe cap (no. 7272350).
Following medication treat-
ment, filter with carbon
(EHFIAKTIV) for 4 - 6 days
to remove medicaments,
then revert to using SUB-
STRATpro
or
EHFISUB-
STRAT, remembering to re-
move the cap from the
breather pipe.
Connect the installed intake pipe and spray bar to the
respective hoses.
Attention:
In order to guarantee the flawless functioning of the
wet/dry filter, the two tubes for the intake and output
must only be shortened to the same length!
Be sure that the tubes are laid out smoothly and that
there are no kinks in them.
TIP:
If you place the tubing into warm water for some
time beforehand, they will become soft and possible
kinks can be easily squeezed out.
°
C
Thermofilter
Heater Installation
Attach
the
temperature
sensor with 2 clips and
suction cups into the tank
in such a manner that it is
positioned beneath the
surface of the water.
Do not install the tempe-
rature sensor near the filter outflow.
The thermostat can be placed on the aquarium hood
or attached with the enclosed Velcro tape to either the
aquarium hood or the pump head of the filter.
Protect against splashing water.
Direct the control cable from the filter canister to the ther-
mostat. Connect the plug – you should hear it snap into
place.
Do not yet connect the
heater's mains plug to the
wall socket.
19
Publicidad
