Troubleshooting; Emergency Measures - Kemper SmartMaster Serie Instrucciones De Servicio

7.3 Troubleshooting

Fault
Not all dust
particles are
collected
Signal horn
sounds
Extraction
capacity too
low/non-
existent
Dust particles
escape on the
clean air side
Device switch
trips
Automatic
Start/Stop does
not function
Product will not
start up
NOTE
If the fault cannot be corrected by the customer, please contact the
manufacturer's service department.

7.4 Emergency measures

In case of fire of the product or its detection elements, the following steps
should be taken if necessary:
1502764-01
Possible cause
Distance between the
extraction hood and the
welding position too great
Clean air outlet obstructed
The set minimum
extraction capacity has not
been reached. Filter inserts
saturated,
piping/extraction system
closed off
Filter inserts saturated
Filter inserts damaged
Motor blocked
Plug in the extraction arm
is bridged
No mains voltage
Tab. 13: Troubleshooting
Note
Move the extraction hood
closer
Keep clean air outlet free of
obstruction
Filter change required,
check piping/extraction
system, contact service
Requirements are no
longer met!
Replace filter inserts
Replace filter inserts
Have this checked by a
qualified electrician
Remove the extraction arm
from the product and
remove the plug bridge
Have this checked by a
qualified electrician
- 66 -
EN