Long Rinsing Programme - Krups EA 8108 Manual De Instrucciones

2 - First rinsing
A first rinsing is needed to eliminate the remaining scale remover.
This cycle is run automatically. It lasts about 6 minutes.
Empty your receptacle
full of waste water.
3 - Second rinsing
At the end of the first rinsing, the 'calc' light will flash.
A second automatic cycle will last 6 minutes.
Remove your waste
water recipient and the
drip tray then fit them
again.
If there is not enough water in the water tank, you will be warned by the
Add the appropriate amount of water to the tank and scale removal will continue automatically.
If a power failure occurs during the cycle, you will have to start it up again from the start.
Be sure to complete the entire scale removal cycle to avoid any risk of intoxication.
The scale removal cycle is a continuous cycle. Do not put your hands under the coffee outlets
during the cycle.
When the cycle has completed, the 'water tank' and 'calc' lights blink.
+
Remove, fill and replace
the water tank.
Empty the drip tray and
then put it back again
together with the
receptacle as
previously.
Again press the
'Service' key. The
'calc' light will
become steady.
A second automatic
cycle will last 6
minutes.
LONG RINSING PROGRAM
Under the coffee out-
lets and steam nozzle
place a recipient that
can contain at least
0.15 L.
Empty, clean and rinse
the water tank and then
fill it again up to the
"Max. level.
Once the second
rinsing is finished,
the 'calc' light will
go off.
Your appliance is now ready for use again.
Launch the long rinse pro-
gram by pressing on the
"Service" button.
The "clean" and "calc"
lights stop blinking.
11
Replace your water
tank. The 'calc' light will
flash and the light
will go off.
Empty the drip tray and
then fit it again.
light.
When the long rinsing
program is complete,
the "clean" and "calc"
lights turn off
± 6 mn
Press the 'Service' key.
The 'calc' light will
become steady. The
automatic cycle will last
6 minutes.
± 6 mn
Empty and then fill
your water tank.