Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
18 English
certain residual risks that cannot be completely
prevented through safety mechanisms. Therefore,
electrical tools must always be operated with the
EN
necessary caution.
ST-EN / 0902
3. Device description
Read all the warnings and instruc-
tions before using the equipment.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Device components
1
On/off switch
2
Electronic adjusting dial
3
Dust hood
4
Base plate
5
Saw bench mounting
6
Clamping wheel
7
Saw blade
8
Clamping lever
9
Dust extractor ø 35 mm
10 Chip-flyoff guard
11 Parallel fence
12 Mains cable module 500 ST E
Fixed supply 420 ST E
13 Interlock button mains cable module
14 Pendulum stroke adjusting knob 500 ST E
Scope of supply
See packaging
Specified conditions of use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ceramic
plates and rubber while resting firmly on the work-
piece. It is suitable for straight and curved cuts
with mitre angles to 45°. The saw blade recom-
mendations are to be observed.
Requirements for the user
The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.
Device description
Publicidad
Tabla de contenido
