Grounding Instructions; Dry Applications; Vacuuming Of Liquids - Nilfisk VHS110 Z22 Manual De Instrucciones

VHS110 Z22

Grounding instructions

This equipment must be grounded. In case of malfunction or
breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. Ground the
supplied cable with the appropriate clamp.
In case of breakage, only use original Nilfisk spare parts.
Any parts that need replacing must be replaced by trained
personnel. Never perform any kind of disassembly, tampering
and/or maintenance on the safety systems.
The above prescriptions, precautions and service
operations must be observed, or the Nilfisk Warranty
for proper operation is void, the Nilfisk Declaration of
Conformity is no longer valid and the User is entirely
responsible for the use of the machine.

Dry applications

The supplied filters must be installed correctly as explained
in section "Primary star filter replacement"
Comply with the safety regulations governing the
vacuumed materials.

Vacuuming of liquids

Comply with the safety regulations governing the
vacuumed materials.
■ Make sure the liquid stop device is working
correctly before vacuuming liquids.
■ In case of foam, immediately stop working, turn off
the machine and empty the container.
■ Regularly clean the liquid level limiting device
and check to make sure that there are no signs of
damage.
■
Dirty liquid vacuumed by the machine must be
GB
considered conductive.
Do not use the machine if the liquid mechanical stop is
not installed!
If it's used without the float, the machine may be
seriously damaged.
When vacuuming a mix of water and air, take care to
avoid overloading the motor of the vacuum unit.
C421
CAUTION!
[ NOTE ]
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
The machine vacuums liquids and deposits them into the
container.
When the machine vacuums liquids it must be equipped with
liquid mechanical stop.
The liquid mechanical stop requires a special container with
relevant nozzle.
Before starting the machine, close the inlet on the filtering
chamber with the relevant plug and fit the vacuum hose in the
inlet on the dust container, then fit the required tool on to the
end part of the hose (refer to the manufacturer's accessory
catalogue or Service Centre).
The liquid mechanical stop stops the vacuuming operation (the
vacuuming units remain activated) when the liquid container is
full; it is then necessary to turn off the machine and empty the
liquid container.
The machine does not switch off automatically.
8