Kenmore 795.7940 Serie Manual De Uso página 26

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WATER FILTER
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed
below. The concentration of the indicated substances in water entering the system was reduced to a concentration
less than or equal to the permissible limit for water leaving the system as
System tested and
Chlorine Taste and Odor and Nominal Particulate Class III.
Capacity: 500 gal (1,892 L)
Substance
Concentration
Nominal Particulate
Class I Particle size: ›0.5 to ‹1 um
Chlorine taste and
odor
Class III
Note that while the testing was performed under standard laboratory conditions, actual performance may vary.
Application Guidelines / Water Supply
Parameters
Service
0.5 gpm (1.89 lpm)
Water pressure
20 - 125 psi (138 - 862
kPa)
Water temperature 33ºF - 100ºF (0.6ºC -
38ºC)
WARNING
To reduce the risk associated with ingestion
of contaminants due to use with water that is
microbiologically unsafe or of unknown
quality. Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system.
Systems must be installed and operated in accordance
with manufacturer's recommended procedures and
guidelines.
USING YOUR REFRIGERATOR
Performance Data Sheet
Models Number ADQ72910907
Use with replacement cartridge ADQ72910907
by NSF International against NSF/ANSI Standard 42 for the reduction of
Challenge
Average
Concentration.
Units apply to
each row
At least 10,000
24,333
particles/ml
1.9
2.0 mg/L ± 10%
in NSF/ANSI 42.
Avg. Product
Average
Water
Concentration
Reduction
915
96
0.07
96.4
CAUTION
To reduce the risk of property damage due to water
leakage:
• Read and follow the Use & Care guide instructions
before installation and use of this system.
• Install on COLD water lines only.
• Comply with all state and local plumbing codes.
• Install a pressure limiting device and water
hammer arrester for inlet water pressures
exceeding 80 psi (552 kPa). Refer to Uniform
• Plumbing Code, Sections 608.2 and 609.10.
• Never install or operate where inlet water pressure
may exceed 120 psi (827 kPa).
• Protect
from freezing. Remove
temperatures below 33° F (0.6° C).
• Replace cartridge at
Cartridge MUST be replaced at least every 6
months.
NOTE: To purchase a replacement filter, visit your local
Sears store, or in the U.S.A. call 1-844-553-6667, and in
Canada 1-800-469-4663.
For web purchase, visit: www.kenmore.com
Replacement Filter: ADQ72910907.
26
NSF % reduction req.
or Max. permissible
%
product water
concentration
≥ 85%
≥ 50%
in
service interval.

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

795.7943 serie

Tabla de contenido