Publicidad
Idiomas disponibles
Idiomas disponibles
Version for narrow profiles (fig. IV)
Remove the attachment sleeve [3] and the pin
■
guide [5] as shown in the picture.
Install the individual parts as depicted and
■
install the accessories [5.1] and [3.1] instead of
the pin guide [5] and attachment sleeve [3].
Version for inulation plate achor (fig. V)
Remove the attachment sleeve [3], the pin guide
■
[5] and the piston [1] as shown in the picture.
Install the individual parts as depicted and
■
install the accessories [1.1], [5.2] and [3.2]
instead of the pin guide [5] , attachment sleeve
[3] and the piston [1].
Warning
It is vital that you mount the brake ring
[7] as shown in the picture and tighten
the union nut [2] properly.
Ensure that the white triangles are at
the same height (symbol ▹◃ fig. II).
Note
After all individual parts have been
assembled and before start of work,
check the device for proper function-
ing.
Fastening elements
Designation
Insulation plate anchor W-DSH
ZEBRA® fastening system
W-PN
Nail HN 101
Nail with steel plate
HNS 103/18
Nail with steel plate
HNS 107/30
Nail with steel plate
UNS 104
Nail with 36 mm disk
UNKT 130
Nail with 66 mm disk
UNKT 160
Formwork stop SA 171
Formwork nail SN 105
M6 pin for steel BFS 6
M6 pin for concrete BFS 6
Special piston for M6 pins
M8 pin for steel BFS 8
M8 pin for concrete BFS 8
Grating fastener
W-GBR M8
Securing shackle FIXB 127
Double securing shackle FIXB
227
Cable bracket KSH 660
Cable clips KBB 530
Prod. no.
0864 650 XXX
0864 100 XXX
0864 101 XXX
0864 103 XXX
0864 107 XXX
0864 104 XXX
0864 130 XXX
0864 160 XXX
0864 171 XXX
0864 105 XXX
0864 111 212
0864 121 632
0864 111 006
0864 081 514
0864 081 527
0864 081 030
0864 127 XX
0864 227 XX
0864 660 00X
0864 530 0XX
19
Publicidad
