GE Baker Hughes PACE CM Instrucciones De Seguridad Y Guía Del Usuario página 5

Introduction
When installed in a PACE instrument, the Pneumatic Control Module measures and controls
pneumatic pressure.
Packaging
On receipt of the Pneumatic Control Module check the contents of the packaging against the
following list:
Packaging List:
i. Pneumatic control module.
ii. User documentation CD (UD-0001).
iii. Calibration certificate.
iv. Diffuser (IO-DIFFUSER-1).
v. Restrictor (IO-SNUBBER-1).
Safety
• Do not use this device for any other purpose than that stated.
• Do not apply pressures above the maximum working pressure (MWP) stated on the
rear panel (Figure A1, item 4).
• Refer to the user manual for general pressure equipment requirements.
Note: Refer to the data sheet 920-561 for the complete range of adaptors.
© 2008 Baker Hughes, a GE company – All rights reserved. PACE CM Safety Instructions and User Guide-English | 1